Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

鄂尔多斯地块周缘垂直形变场负位错反演与应变积累研究     

张希  刘立炜  郝明  白卓立 《大地测量与地球动力学》2019,39(6):551-556

利用鄂尔多斯地块及其周缘1970～2014年的垂直形变速率场资料，借助负位错反演研究该区域长期应变积累。结果表明，地块东北缘山西断陷带中北段年均能量积累增量、剪应力强度都较高，西南缘六盘山断裂与渭河断裂西段次之；山西断陷带中南段至晋陕交界处年均剪应力强度较高且显示一定程度的能量积累；西秦岭构造区尤其西秦岭北缘断裂西段、晋冀蒙交界区也反映一定程度的能量积累特性。  相似文献   

铜藻(Sargassum horneri)在营养限制胁迫后对NH₄-N的超补偿吸收研究     

李大鹏  马增岭  李慧  丁刚  辛美丽  吴海一  郭文 《海洋与湖沼》2018,49(4):904-909

以经济马尾藻铜藻(Sargassum horneri)为研究材料,研究了其在营养限制胁迫后对NH_4-N的超补偿吸收情况。实验分营养限制和恢复营养两个阶段进行,每个阶段均设置饥饿处理组、饱和处理组和正常对照组。铜藻在低营养限制胁迫(饥饿)下培养10天后,恢复营养盐培养3天,分别采用次溴酸盐氧化法和锌镉还原法测定培养液中的NH_4-N和NO_3-N的浓度。本文研究发现,饥饿处理组中铜藻吸收氨氮的速率远高于正常对照组和饱和处理组,在恢复培养第一天时,饥饿处理组对NH_4-N的吸收速率最高为14.94μmol/(g·h),与正常对照组及饱和处理组间差异显著。在恢复培养的后两天,三个处理组中铜藻对NH_4-N的吸收速率差异慢慢变小,直至最后几乎相同。三组对NO_3-N没有表现出较高的吸收,最高仅为6.15μmol/(g·h),结果表明:氮源包括NH_4-N和NO_3-N时,铜藻优先选择吸收NH_4-N。实验后称重测定生长速率:对照组、饥饿处理组和饱和组生长率(SGR)分别为8.48%、8.86%、8.01%,ANOVA方差分析表明,三者存在显著差异(P=0.0320.05),从而证实了铜藻也存在超补偿生长的现象。  相似文献   

基于圆柱多段拟合的隧道中轴线提取方法研究     

荆海峰  李广云  王力  杨文锋 《大地测量与地球动力学》2018,38(2):211-215

提出基于圆柱多段拟合的隧道中轴线提取方法。首先对隧道点云数据进行预处理，并将点云按隧道走向分成不同区段；然后对各区段依据轴线与表面点云法线垂直关系，提取精度较低的中轴线；最后对各区段利用圆柱多段拟合，提取精度较高的中轴线。实验表明，隧道中轴线的提取在一定的采样区间具有较高的稳定性，对直线和弯曲的圆形隧道有良好的适用性，算法可靠，精度较高。  相似文献   

利用短期静态PPP结果反演海潮负荷位移     

魏国光  王琪洁  彭葳  郭良琦 《大地测量与地球动力学》2019,39(6):607-612

采用香港11个GPS测站的观测资料进行1 h、2 h、3 h和4h静态PPP解算，获得4组PPP坐标序列，利用调和分析求取11个测站处8个主要分潮的负荷位移参数（振幅和相位），将其与海潮模型计算的负荷位移参数进行对比，并比较分析PPP反演值与海潮模型值改正海潮负荷信号的效果。结果表明，垂直和水平方向上，不同PPP结果反演8个分潮的负荷位移分别具有约5 mm和7 mm的差异；PPP反演8个分潮垂向负荷位移优于全球海潮模型，但水平方向上的反演效果稍弱。  相似文献   

资源三号和天绘一号卫星影像无控联合平差精度分析     

郑义  张宏伟  杜晓  张俊辉  周琦  林尚纬  陈利军 《测绘通报》2020,(7):10

近年来国产卫星传感器类型日益丰富，使用自主可控的国产卫星影像进行生产和研究的需求越来越大，多源国产卫星影像联合平差的精度分析显得尤为重要。本文针对在立体测图生产中，资源三号卫星影像在时相较旧、噪声较大、云覆盖和摄影漏洞等特殊困难的条件下，利用天绘一号卫星影像进行补漏生产的情况，最终分析并验证了两者无控联合平差的可行性和成果精度。  相似文献   

基于重力测点和段差变化的前郭5.8级震群研究与三维反演     

王同庆  张品  刘金钊  陈兆辉  张双喜  朱传东 《大地测量与地球动力学》2019,39(5):469-475

利用东北地区近几年流动重力观测数据，分析前郭5.8级震群周边重力点值的时序变化特征，并基于重力段差变化对东北地区整体和局部重力变化引入能够反映异常显著性程度的指标量G和C值，最后对前郭5.8级震群前的重力场动态变化作三维密度反演。结果表明：1）前郭5.8级震群发震构造两侧的局部重力变化具有较明显的差异性，其变化趋势可作为识别构造活化或解耦运动的标志；2）显著性指标量G和C值能够为地震重力前兆的定量描述提供新思路；3）震前重力变化的反演结果显示地震发生在质量运移的过渡区域，垂向反演结果对本次地震的震源深度有一定的揭示意义。  相似文献   

Muon density measurements with the KASCADE central detector     

《Astroparticle Physics》2002,16(4):183-386

Frequency distributions of local muon densities in high-energy extensive air showers (EAS) are presented as signature of the primary cosmic ray energy spectrum in the knee region. Together with the gross shower variables like shower core position, angle of incidence, and the shower sizes, the KASCADE experiment is able to measure local muon densities for two different muon energy thresholds. The spectra have been reconstructed for various core distances, as well as for particular subsamples, classified on the basis of the shower size ratio N_μ/N_e. The measured density spectra of the total sample exhibit clear kinks reflecting the knee of the primary energy spectrum. While relatively sharp changes of the slopes are observed in the spectrum of EAS with small values of the shower size ratio, no such feature is detected at EAS of large N_μ/N_e ratio in the energy range of 1–10 PeV. Comparing the spectra for various thresholds and core distances with detailed Monte Carlo simulations the validity of EAS simulations is discussed.  相似文献   

On the accretion geometry of Cyg X-1 in the low/hard state     

F. Eugenio Barrio  Chris Done  Sergei Nayakshin 《Monthly notices of the Royal Astronomical Society》2003,342(2):557-563

  相似文献